QC Inspector - Pipe (Saudi nationals only)

Our client is a leading manufacturer of composite pipe systems for a variety of applications in the oil and gas, water and industrial sectors.

JOB PURPOSE This position is open to Saudi nationals only.

Responsible for ensuring that all the Pipes and Couplers are manufactured to the quality standards laid down and that every item is inspected and stamped QC OK when ready for release to the Final Warehouse.

KEY ACCOUNTABILITIES Policies & Procedures

Comply with operational procedures and instructions when performing all job tasks and activities

In-process inspection

Ensure only approved and QC accepted raw materials are used in the manufacturing process

Ensure that the production process comply with the technical Know-How documents & Quality Assurance Procedures

Conduct the refractive index check of the epoxy resin / hardener mix ratio to ensure it meets the set requirements

Check and monitor the ambient temperature and humidity

Witness the production processes and ensure that the relevant approved Raw Material Calculation and Machine Set ups are followed to meet the project requirements

Inform the non-conformances immediately to the responsible Machine Captains and other employees in the Production and QC departments so corrective actions can be taken

Online / Offline Inspection of Pipes and Couplers

Inspect the Pipes and Couplers as per the requirements of product drawings following the inspection and testing program

Select QC samples during the production process as per the inspection program and / or project ITPs as applicable

Trading materials inspection

Inspect the products purchased from the other manufacturing units or sub supplier and ensure that those products meet the project specification requirements and release them for delivery

Inspect the locking strips, different types of gaskets such as Kroll and Ziller, O-rings, flat gaskets in order to ensure the quality meets the minimum specified requirements

Non-destructive testing

Conduct the non-destructive tests as per the ITP requirement

Witness the routine hydro tests for the Pipes and Couplers

Destructive Testing

Conduct the destructive tests in accordance to the ITP requirements and project commitments agreed with the Client / consultant

Witness and monitor the short term and medium term survival tests periodically and ensure the tests are not affected with any climatic effects and successfully completed as per the project requirements

Preparation of reports, TPI inspection and release

Prepare the daily QC internal reports as well as project specific documentation (Manufacturing Record Book - MRB) to be submitted to the Client

Carry out the final inspection and release together with the Customer TPIs and Client TPIs for all the products comes under the major projects based on the project specific requirements. Also perform additional tests as per the ITP for the witness point of Customer / Client

Stock counting

Participate and lead a small team of employees during the Half- yearly and Yearly stock counts to ensure that the physical inventory matches the ERP system inventory

Carry out monthly stock counting for the major raw materials in the stores warehouse and provide the actual data to the QC Engineer for monthly RM stock count report

Mould & Socket Sleeve inspection

Carry out steel mould and socket sleeve inspection either at factory or at supplier’s premises as per the relevant engineering drawings to ensure that those moulds are manufactured as per the given approved drawings

HSE

Comply with relevant safety, quality and environmental control procedures and instructions

Use personal protective equipment and safety gear when performing assigned tasks

Keep operational areas clean and well organized to prevent incidents and accidents

Report unsafe acts, incidents or safety violations

Develop a safety culture by ensuring all staff comply with HSE policies and procedures

Participate in QHSE audits, incident reporting and review of QHSE performances as required

Skills Required Qualifications :

Technical School Certificate / On Job Training

Mandatory - OCTG and API thread inspection experience

Preferred Experience :

3-5years of pipe manufacturing experience

Engineering Degree / Diploma (Civil or Mechanical)

Job-Specific Skills :

QC inspection and testing of Raw Material and finished products.

Reading and interpretation of engineering drawings

Ability to prepare reports

Ability to use measuring and testing equipment

STRAGO, an equal employment opportunity employer, is recruiting on behalf of our client. If your application aligns closely with the required profile, you will be contacted to proceed with the selection process.

#J-18808-Ljbffr